05-Network Connectivity

HomeSupportConfigure & DeployConfiguration GuidesH3C Access Controllers Configuration Guides(R5447P04)-6W10005-Network Connectivity
28-IPv6 static routing configuration
Title Size Download
28-IPv6 static routing configuration 53.30 KB

Configuring IPv6 static routing

About IPv6 static routing

Static routes are manually configured and cannot adapt to network topology changes. If a fault or a topological change occurs in the network, the network administrator must modify the static routes manually. IPv6 static routing works well in a simple IPv6 network.

Configuring an IPv6 static route

1.     Enter system view.

system-view

2.     Configure an IPv6 static route.

ipv6 route-static ipv6-address prefix-length { interface-type interface-number [ next-hop-address ] | next-hop-address } [ permanent ] [ preference preference ] [ tag tag-value ] [ description text ]

By default, no IPv6 static route is configured.

3.     (Optional.) Set the default preference for IPv6 static routes.

ipv6 route-static default-preference default-preference

The default setting is 60.

Deleting IPv6 static routes

About this task

To delete an IPv6 static route, use the undo ipv6 route-static command. To delete all IPv6 static routes including the default route, use the delete ipv6 static-routes all command.

Procedure

1.     Enter system view.

system-view

2.     Delete all IPv6 static routes, including the default route.

delete ipv6 static-routes all

 

CAUTION

CAUTION:

This command might interrupt network communication and cause packet forwarding failure. Before executing the command, make sure you fully understand the potential impact on the network.

Display and maintenance commands for IPv6 static routing

Execute display commands in any view.

 

Task

Command

Display IPv6 static route next hop information.

display ipv6 route-static nib [ nib-id ] [ verbose ]

Display IPv6 static routing table information.

display ipv6 route-static routing-table [ ipv6-address prefix-length ]

Display IPv6 static route information.

display ipv6 routing-table protocol static [ inactive | verbose ]

 

For more information about the display ipv6 routing-table protocol static [ inactive | verbose ] command, see basic IP routing in Network Connectivity Command Reference.

 

 


Configuring an IPv6 default route

A default IPv6 route is used to forward packets that match no entry in the routing table.

A default IPv6 route can be configured in either of the following ways:

·     The network administrator can configure a default route with a destination prefix of ::/0. For more information, see "Configuring IPv6 static routing."

·     Some dynamic routing protocols (such as RIPng) can generate a default IPv6 route. For example, an upstream router running a dynamic routing protocol can generate a default IPv6 route and advertise it to other routers. These routers install the default IPv6 route with the next hop being the upstream router. For more information, see the respective chapters on those routing protocols in this configuration guide.

  • Cloud & AI
  • InterConnect
  • Intelligent Computing
  • Security
  • SMB Products
  • Intelligent Terminal Products
  • Product Support Services
  • Technical Service Solutions
All Services
  • Resource Center
  • Policy
  • Online Help
All Support
  • Become a Partner
  • Partner Resources
  • Partner Business Management
All Partners
  • Profile
  • News & Events
  • Online Exhibition Center
  • Contact Us
All About Us
新华三官网