Table of Contents

Related Documents

04-Appendix B LEDs and buttons

Title	Size	Download
04-Appendix B LEDs and buttons	49.21 KB

4 Appendix B LEDs and buttons

LEDs and buttons

The LED status varies by AP operating mode. For information about the supported operating modes, see the release notes for the AP.

Table 4-1 LED descriptions (fit mode)

LED status			Description
Off		No power is present or the LED has been turned off.
Yellow	Steady on	The AP is initializing, or an initialization exception has occurred.
Yellow	Flashing (twice per second)	The Ethernet interfaces are down and no mesh links are established.
Green	Steady on	The AP has registered to an AC, but does not have any associated clients.
	Flashing (once per two seconds)	The AP has started up but has not registered to any AC.
	Flashing (twice per second)	The AP is upgrading the image.
Blue	Flashing (once per second)	The radios have associated clients.

Table 4-2 LED descriptions (cloud mode)

LED status			Description
Off		No power is present or the LED has been turned off.
Yellow	Steady on	The AP is initializing, or an initialization exception has occurred.
Yellow	Flashing (twice per second)	The Ethernet interfaces are down and no mesh links are established.
Green	Steady on	The AP is in standby state and has connected to the Cloudnet platform, but does not have any associated clients.
	Flashing (once per second)	The AP has connected to the Cloudnet platform and has associated clients.
	Flashing (twice per second)	The AP is upgrading the image.
Blue	Steady on	The AP is in standby state, but has not connected to the Cloudnet platform and does not have associated clients.
Blue	Flashing (once per second)	The AP has not connected to the Cloudnet platform, but has associated clients.

NOTE:

Only the WA7539 supports Anchor Acmode.

Table 4-3 LED descriptions (anchor AC mode)

LED status			Description
Off		No power is present or the LED has been turned off.
Yellow	Steady on	The AP is initializing, or an initialization exception has occurred.
Yellow	Flashing (twice per second)	The Ethernet interfaces are down and no mesh links are established.
Green	Steady on	The AP has started up and is in standby state, but does not have any associated clients.
Green	Flashing (twice per second)	The AP is upgrading the image.
Blue	Flashing (once per second)	The AP has associated clients.

Table 4-4 RESET button descriptions

Press and hold duration (sec)	Button LED status		Description
0 to 5	Steady green		Reset the AP.
5 to 20	Flashing green (twice per second)		Restore to the factory defaults.
20 to 30	Yellow	Flashing (once per two seconds)	The AP is operating in fit AP mode. NOTE: The system will change the operating mode to cloud if you press and hold the button until the LED flashes green four times per second.
		Flashing (twice per second)	The AP is operating in anchor AC mode. NOTE: Only the WA7539 supports Anchor Acmode.
		Flashing (four times per second)	The AP is operating in cloud mode.
> 30	Yellow	Flashing (twice per second)	The AP is operating in anchor AC mode. NOTE: Only the WA7539 supports Anchor Acmode.
	Yellow	Flashing (four times per second)	The AP is operating in cloud mode.
	Green	Flashing (four times per second)	Change the AP operating mode to cloud. NOTE: If you release the button, the AP will restart for the new mode to take effect.