Login
- Table of Contents
-
- 05-Layer 2—LAN Switching Configuration Guide
- 00-Preface
- 01-MAC address table configuration
- 02-Ethernet link aggregation configuration
- 03-M-LAG configuration
- 04-Port isolation configuration
- 05-VLAN configuration
- 06-QinQ configuration
- 07-Loop detection configuration
- 08-Spanning tree configuration
- 09-LLDP configuration
- 10-PFC configuration
- 11-Service loopback group configuration
- Related Documents
-
| Title | Size | Download |
|---|---|---|
| 11-Service loopback group configuration | 52.11 KB |
Configuring service loopback groups
Restrictions and guidelines: Service loopback group configuration
Configuring a service loopback group
Verifying and maintaining service loopback groups
Configuring service loopback groups
About service loopback groups
A service loopback group can provide only the telemetry stream services.
Restrictions and guidelines: Service loopback group configuration
When you add member ports to a service loopback group, follow these restrictions and guidelines:
· Make sure the ports support the service type of the service loopback group and are not members of any other service loopback group.
· Breakout interfaces cannot be assigned to service loopback groups.
When you apply service loopback groups to features, follow these restrictions and guidelines:
· One service loopback group can be used by multiple features.
· Do not delete a service loopback group that is being used by a feature.
Configuring a service loopback group
1. Enter system view.
system-view
2. Create a service loopback group and specify its service type.
service-loopback group group-id type telemetry-stream
You can configure only one service loopback group for a service type.
3. Enter Layer 2 Ethernet interface view.
interface interface-type interface-number
4. Assign the port to the service loopback group.
port service-loopback group group-id
By default, a port does not belong to a service loopback group.
|
|
CAUTION: · The configuration on a port is removed when it is assigned to a service loopback group. Make sure you fully understand the impact on your network when you assign a port to a service loopback group. · If a port is the only member of a referenced service loopback group, then removing that port from the group will disrupt the functionality of the telemetry stream. |
Verifying and maintaining service loopback groups
To display information about service loopback groups, execute the following command in any view:
display service-loopback group [ group-id ]
