Login
- Table of Contents
-
- 04-DPI Command Reference
- 00-Preface
- 01-DPI engine commands
- 02-IPS commands
- 03-URL filtering commands
- 04-Data filtering commands
- 05-File filtering commands
- 06-Anti-virus commands
- 07-Data analysis center commands
- 08-Proxy policy commands
- 09-WAF commands
- 10-APT defense commands
- 11-IP reputation commands
- 12-Domain reputation commands
- 13-DGA detection commands
- 14-Intelligent service platform commands
- Related Documents
-
| Title | Size | Download |
|---|---|---|
| 14-Intelligent service platform commands | 51.15 KB |
Intelligent service platform commands
The following compatibility matrix shows the support of hardware platforms for intelligent service platform:
|
Series |
Models |
Intelligent service platform compatibility |
|
F5000 series |
F5000-AI-40, F5000-AI-20, F5000-AI-15 |
Yes |
|
F5000-AI160, F5000-CN160, F5000-CN-G85, F5000-CN-G65, F5000-CN-G55 |
No |
|
|
F1000 series |
F1000-AI-25 |
Yes |
display intelligent-inspect status
Use display intelligent-inspect status to display the connection status of the intelligent service platform.
Syntax
display intelligent-inspect status
Views
Any view
Predefined user roles
network-admin
Examples
# Display the connection status of the intelligent service platform.
<Sysname> display intelligent-inspect status
State: Connected.
Table 1 Command output
|
Field |
Description |
|
State |
Connection status of the intelligent service platform: · Connected—The device is connected to the intelligent service platform. · Disconnected—The device is disconnected from the intelligent service platform. |
Related commands
intelligent-inspect ip
intelligent-inspect ip
Use intelligent-inspect ip to assign an IP address to the intelligent service platform.
Use undo intelligent-inspect ip to restore the default.
Syntax
intelligent-inspect ip ip-address
undo intelligent-inspect ip
Default
The intelligent service platform does not have an IP address.
Views
System view
Predefined user roles
network-admin
Parameters
ip-address: Specifies an IP address.
Usage guidelines
This address acts as the IP address of the internal Ethernet interface. The device communicates with the intelligent service platform through this IP address.
Only IPv4 addresses can be configured for the intelligent service platform.
Examples
# Assign IP address 192.22.1.30 to the intelligent service platform.
<Sysname> system-view
[Sysname] intelligent-inspect ip 192.22.1.30
Related commands
enhanced-inspect anti-virus enable
service enable
