- Released At: 02-01-2023
- Page Views:
- Downloads:
- Table of Contents
- Related Documents
-
H3C LSEM1GT48TS24QSSD0 interface module
1 Identifier
The module identifier LSEM1GT48TS24QSSD0 is at the upper left corner of the front panel.
2 Specifications
Table 1 Module specifications
Item |
Specification |
Dimensions (H × W × D) |
51 × 423 × 270 mm (2.01 × 16.65 × 10.63 in) |
Power consumption |
52 W to 115 W |
Ports |
· 48 × 10/100/1000BASE-T copper ports · 24 x 10GBASE-R-SFP+ fiber ports · 2 x 40GBASE-R-QSFP+ fiber ports |
Port transmission rate |
· QSFP+: 40 Gbps · SFP+: 10 Gbps · 10/100/1000BASE-T: 10/100/1000 Mbps |
IMPORTANT: · To verify the compatibility of the module with the software release you are using, see the release notes. · For information about transceiver modules and cables available for the module, see the cards and transceiver modules compatibility matrixes for the device. |
To ensure normal use of the ports, use the following types of cables:
· Cables without strain-relief boots.
Figure 1 Cable without strain-relief boots
· Cables with strain-relief boots. Make sure the boot thickness is not larger than that of the RJ-45 connector.
Figure 2 Cable with a strain-relief boot whose thickness is not larger than that of the RJ-45 connector
Figure 3 Cable with a strain-relief boot whose thickness is larger than that of the RJ-45 connector
3 Related documentation
For information about module installation, see the installation guide for the device.
For software upgrade, see the release notes.
Copyright © 2022 New H3C Technologies Co., Ltd.
The information in this document is subject to change without notice.