- Released At: 13-12-2022
- Page Views:
- Downloads:
- Table of Contents
- Related Documents
-
H3C CR-HIC-ET16 E1 copper interface card
1 Identifier
The module identifier CR-HIC-ET16 is in the upper right corner of the front panel.
2 About the module
The CR-HIC-ET16 E1 copper interface card provides 16 E1 ports (HM96 male connector).
Figure 1 Front panel
(1) E1 ports and LEDs 1 to 16 |
(2) Module identifier (CR-HIC-ET16) |
Table 1 Module specifications
Item |
Specifications |
Dimensions (H × W × D) |
21 × 195 × 162 mm (0.83 × 7.68 × 6.38 in) |
Power consumption |
11 W |
Ports |
16 × E1 ports (HM96 male connector) |
Connector type |
HM96 |
Interface transmission rate |
2.048 Mbps |
Hot swapping |
Supported |
Cable impedance |
75/120 ohms |
Table 2 Available E1 cables
Cable |
Description |
SR0M7CAB1 |
HM-96pin E1 Cable (75 ohm, 3 m, BNC) |
SR0M7CAB2 |
HM-96pin E1 Cable (120 ohm, 3 m, RJ45) |
SR0M7CAB3 |
HM-96pin E1 Cable (75 ohm, 3 m, SMB) |
IMPORTANT: · To verify compatibility of the module with the software release you are using, see the release notes. · For interface card compatibility with the interface modules, see the hardware information and specifications for the device. |
Copyright © 2022 New H3C Technologies Co., Ltd.
The information in this document is subject to change without notice.