Login
- Table of Contents
- Related Documents
-
| Title | Size | Download |
|---|---|---|
| 01-Radio Management Configuration Example | 121.73 KB |
|
|
|
H3C Access Controllers |
|
Comware 7 Radio Management |
|
Configuration Example |
Copyright © 2024 New H3C Technologies Co., Ltd. All rights reserved.
No part of this manual may be reproduced or transmitted in any form or by any means without prior written consent of New H3C Technologies Co., Ltd.
Except for the trademarks of New H3C Technologies Co., Ltd., any trademarks that may be mentioned in this document are the property of their respective owners.
The information in this document is subject to change without notice.
Overview
The following information provides an example for configuring radio management.
Prerequisites
The following information applies to Comware 7-based access controllers. Procedures and information in the examples might be slightly different depending on the software or hardware version of the H3C access controllers.
The configuration examples were created and verified in a lab environment, and all the devices were started with the factory default configuration. When you are working on a live network, make sure you understand the potential impact of every command on your network.
The following information is provided based on the assumption that you have basic knowledge of radio management.
Example: Configuring radio management
Network configuration
As shown in Figure 1, create a manual AP and set the radio mode, working channel, and maximum transmit power to 802.11gn, channel 11, and 19 dBm, respectively.
Procedures
1. Click the Network View tab at the bottom of the page.
2. From the navigation pane, select Wireless Configuration > Radio Management.
3. Click the More icon 
in
the upper right corner of the Radios
for all APs area.
4. Click the Edit icon 
for
radio 2.4GHz(2) of AP ap1 and configure the radio as follows:
¡ Set the radio mode to 802.11n(2.4GHz).
¡ Set the working channel to 11.
¡ Set the maximum power to 19 dBm.
¡ Select On from the Status field.
Figure 2 Configuring basic radio settings
Verifying the configuration
1. Click the Network View tab at the bottom of the page.
2. From the navigation pane, select Wireless Configuration > Radio Management.
3. Verify that the radio is configured correctly.
Figure 3 Verifying the configuration
Related documentation
H3C Access Controllers Web-Based Configuration Guide
