04-Network Connectivity Command Reference

HomeSupportResource CenterH3C Access Points Cloud Mode Command References(E2442 R2442)-6W10004-Network Connectivity Command Reference
03-Port isolation commands
Title Size Download
03-Port isolation commands 39.85 KB

Port isolation commands

display port-isolate group

Use display port-isolate group to display port isolation group information.

Syntax

display port-isolate group

Views

Any view

Predefined user roles

network-admin

network-operator

Examples

# Display port isolation group information.

<Sysname> display port-isolate group

 Port isolation group information:

 Group ID: 1

 Group members:

    GigabitEthernet1/0/2

Table 1 Command output

Field

Description

Group ID

ID of the isolation group.

Group members

Isolated ports in the isolation group. No ports indicates that the isolation group does not contain isolated ports.

 

Related commands

port-isolate enable

port-isolate enable

Use port-isolate enable to assign a port to an isolation group.

Use undo port-isolate enable to remove a port from an isolation group.

Syntax

port-isolate enable

undo port-isolate enable

Default

The port is not assigned to an isolation group.

Views

Layer 2 Ethernet interface view

Layer 2 aggregate interface view

Predefined user roles

network-admin

Usage guidelines

The configuration in Layer 2 Ethernet interface view applies only to the interface.

The configuration in Layer 2 aggregate interface view applies to the Layer 2 aggregate interface and its aggregation member ports. If the device fails to apply the configuration to the aggregate interface, it does not assign any aggregation member port to the isolation group. If the failure occurs on an aggregation member port, the device skips the port and continues to assign other aggregation member ports to the isolation group.

You cannot assign the member ports of a service loopback group to an isolation group, and vice versa.

This command assigns a port to the default isolation group (isolation group 1).

Examples

# Assign GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 to the default isolation group.

<Sysname> system-view

[Sysname] interface gigabitethernet 1/0/1

[Sysname-GigabitEthernet1/0/1] port-isolate enable

[Sysname-GigabitEthernet1/0/1] quit

[Sysname] interface gigabitethernet 1/0/2

[Sysname-GigabitEthernet1/0/2] port-isolate enable

# Assign Layer 2 aggregate interface Bridge-Aggregation 1 to the default isolation group.

<Sysname> system-view

[Sysname] interface bridge-aggregation 1

[Sysname-Bridge-Aggregation1] quit

[Sysname] interface gigabitethernet 1/0/1

[Sysname-GigabitEthernet1/0/1] port link-aggregation group 1

[Sysname-GigabitEthernet1/0/1] quit

[Sysname] interface gigabitethernet 1/0/2

[Sysname-GigabitEthernet1/0/2] port link-aggregation group 1

[Sysname-GigabitEthernet1/0/2] quit

[Sysname] interface bridge-aggregation 1

[Sysname-Bridge-Aggregation1] port-isolate enable

Related commands

display port-isolate group