Contents

Configuring service loopback groups· 1

Overview· 1

Configuration restrictions and guidelines· 1

Configuring a service loopback group· 2

Displaying and maintaining service loopback groups· 2

Service loopback group configuration example· 2

Network requirements· 2

Configuration procedure· 2

Configuring service loopback groups

Overview

A service loopback group contains one or multiple Ethernet ports for looping packets sent out by the device back to the device. This feature must work with other features, such as GRE.

A service loopback group provides one of the following services:

·     Tunnel—Supports unicast tunnel traffic.

·     Multicast tunnel—Supports multicast tunnel traffic.

Member ports in a service loopback group are load balanced.

Configuration restrictions and guidelines

When you configure service loopback groups, follow these restrictions and guidelines:

·     The maximum number of service loopback groups and the maximum number of member ports allowed in a service loopback group vary by location of member ports, as shown in the following matrix:

·     Assign ports with the same rate to the same service loopback group for load balancing.

·     Make sure the ports you are assigning to a service loopback group meet the following requirements:

¡     The ports are not used for any other purposes. The configuration on a port is removed when it is assigned to a service loopback group.

¡     The ports support the service type of the service loopback group and are not members of any other service loopback group.

·     You can configure only one service loopback group for a service type. However, you can use one service loopback group with multiple features.

·     Do not change the service type of a service loopback group.

·     Do not delete a service loopback group that is being used by a feature.

·     For correct traffic processing, make sure a service loopback group has a minimum of one member port when it is being used by a feature.

Configuring a service loopback group

Displaying and maintaining service loopback groups

Execute display commands in any view.

Service loopback group configuration example

Network requirements

All Ethernet ports on Device A support the tunnel service. Assign GigabitEthernet 1/0/1 through GigabitEthernet 1/0/3 to a service loopback group to loop GRE packets sent out by the device back to the device.

Configuration procedure

# Create service loopback group 1, and specify its service type as tunnel.

<DeviceA> system-view

[DeviceA] service-loopback group 1 type tunnel

# Assign GigabitEthernet 1/0/1 through GigabitEthernet 1/0/3 to service loopback group 1.

[DeviceA] interface gigabitethernet 1/0/1

[DeviceA-GigabitEthernet1/0/1] port service-loopback group 1

All configurations on the interface will be lost. Continue?[Y/N]:y

[DeviceA-GigabitEthernet1/0/1] quit

[DeviceA] interface gigabitethernet 1/0/2

[DeviceA-GigabitEthernet1/0/2] port service-loopback group 1

All configurations on the interface will be lost. Continue?[Y/N]:y

[DeviceA-GigabitEthernet1/0/2] quit

[DeviceA] interface gigabitethernet 1/0/3

[DeviceA-GigabitEthernet1/0/3] port service-loopback group 1

All configurations on the interface will be lost. Continue?[Y/N]:y

[DeviceA-GigabitEthernet1/0/3] quit

# Create the interface Tunnel 1 and set it to GRE mode. The interface will automatically use service loopback group 1.

[DeviceA] interface tunnel 1 mode gre

[DeviceA-Tunnel1]