Login
- Table of Contents
-
- 09-Security Command Reference
- 00-Preface
- 01-AAA commands
- 02-802.1X commands
- 03-MAC authentication commands
- 04-Portal commands
- 05-Web authentication commands
- 06-Port security commands
- 07-User profile commands
- 08-Password control commands
- 09-Keychain commands
- 10-Public key management commands
- 11-PKI commands
- 12-IPsec commands
- 13-SSH commands
- 14-SSL commands
- 15-Attack detection and prevention commands
- 16-TCP attack prevention commands
- 17-IP source guard commands
- 18-ARP attack protection commands
- 19-ND attack defense commands
- 20-uRPF commands
- 21-MFF commands
- 22-Crypto engine commands
- 23-FIPS commands
- 24-MACsec commands
- Related Documents
-
| Title | Size | Download |
|---|---|---|
| 20-uRPF commands | 32.02 KB |
uRPF commands
display ip urpf
Use display ip urpf to display uRPF configuration.
Syntax
display ip urpf [ interface interface-type interface-number ] [ slot slot-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface interface-type interface-number: Specifies an interface by its type and number.
slot slot-number: Specifies an IRF member device by its member ID. If you do not specify a member device, this command displays uRPF configuration for all member devices.
Examples
# Display uRPF configuration for the specified slot.
<Sysname> display ip urpf slot 1
Global uRPF configuration information(failed):
Check type: strict
# Display uRPF configuration on the specified interface.
<Sysname> display ip urpf interface vlan-interface 10 slot 1
uRPF configuration information of interface Vlan-interface10(failed):
Check type: loose
Table 1 Command output
|
Field |
Description |
|
(failed) |
The system failed to deliver the uRPF configuration to the forwarding chip because of insufficient chip resources. This field is not displayed if the delivery is successful. |
|
Check type |
uRPF check mode: loose or strict. |
ip urpf
Use ip urpf to enable uRPF.
Use undo ip urpf to disable uRPF.
Syntax
ip urpf { loose | strict }
undo ip urpf
Default
uRPF is disabled.
Views
System view
Interface view
Predefined user roles
network-admin
Parameters
loose: Enables loose uRPF check. To pass loose uRPF check, the source address of a packet must match the destination address of a FIB entry.
strict: Enables strict uRPF check. To pass strict uRPF check, the source address and receiving interface of a packet must match the destination address and output interface of a FIB entry.
Usage guidelines
uRPF can be deployed on a PE connected to a CE or an ISP, or on a CE.
Examples
# Enable strict uRPF check globally.
<Sysname> system-view
[Sysname] ip urpf strict
# Configure loose uRPF check on VLAN-interface 10.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ip urpf loose
Related commands
display ip urpf
