Login
- Table of Contents
-
- 01-System Management
- 01-Telnet Access Control Configuration Example
- 02-IPv6 Telnet Access Control Configuration Example
- 03-Web Access Control Configuration Example
- 04-User Role Assignment for Local Web Authentication Users Configuration Example
- 05-SSH Local Authentication Configuration Example
- 06-SSH User Remote Password Authentication Configuration Example
- 07-IPv6 SSH User Remote Password Authentication Configuration Example
- 08-Password Control Configuration Example
- Related Documents
-
| Title | Size | Download |
|---|---|---|
| 08-Password Control Configuration Example | 153.88 KB |
|
|
|
H3C Access Controllers |
|
Comware 7 Password Control |
|
Configuration Example |
Copyright © 2024 New H3C Technologies Co., Ltd. All rights reserved.
No part of this manual may be reproduced or transmitted in any form or by any means without prior written consent of New H3C Technologies Co., Ltd.
Except for the trademarks of New H3C Technologies Co., Ltd., any trademarks that may be mentioned in this document are the property of their respective owners.
The information in this document is subject to change without notice.
Overview
The following information provides an example for configuring password control.
Prerequisites
The following information applies to Comware 7-based access controllers. Procedures and information in the examples might be slightly different depending on the software or hardware version of the H3C access controllers.
The configuration examples were created and verified in a lab environment, and all the devices were started with the factory default configuration. When you are working on a live network, make sure you understand the potential impact of every command on your network.
The following information is provided based on the assumption that you have basic knowledge of password control.
Example: Configuring password control
Network configuration
As shown in Figure 1, configure a password control policy on the AC. The user passwords must meet the following requirements:
· A password must contain a minimum of 10 characters.
· A password must contain a minimum of three character types and a minimum of two characters for each type.
If a user password does not meet these requirements, the user is prompted to change the password.
Prerequisites
Make sure the AC and the client can reach each other.
Procedures
1. Configure IP settings, VLAN, AP access, and radio status on the AC. (Details not shown.)
2. Click the System View tab at the bottom of the page.
3. From the navigation pane, select System > Administrators.
4. Click the Password
control button 
at
the upper right of the page.
Figure 2 Entering the password control page
5. Click Enable Password Control.
Figure 3 Enabling password control
6. Configure password control settings.
a. Set the minimum password length to 10 characters.
b. Set the number of character types to three.
c. Set the number of characters for each type to two.
d. Set the password aging time to 90 days.
Figure 4 Configuring password control settings
Verifying the configuration
Verify that you are prompted to change the password after entering the username and the initial password on the login page for the first time.
Figure 5 Changing the password
Related documentation
H3C Access Controllers Web-Based Configuration Guide
