H3C S12516X-AF LSXM1SFH16E1 Card Manual-6PW102

HomeSupportResource CenterSwitchesS12500X-AF SeriesS12500X-AF SeriesTechnical DocumentsInstall & UpgradeSwitching Fabric Card ManualsH3C S12516X-AF LSXM1SFH16E1 Card Manual-6PW102
Download Book
Table of Contents
Related Documents

LSXM1SFH16E1 switching fabric module

1  Identifier

The card identifier LSXM1SFH16E1 is at the upper right corner of the front panel.

2  Specifications

Table 1 Card specifications




MIPS64 (Dual Core) @ 1 GHz



Power consumption

487 W to 816 W

Compatible device models


Compatible interface cards

Type H interface cards




·     Before you install the card on the switch, make sure the system software supports the card. For information about software and hardware compatibilities with the system software, see the release notes for the system software.

·     Remove the protection box from the card before you install the card.

·     You must install the cards before you install the fan trays, and remove the fan trays before you remove the cards.

·     Follow these instructions to use the ejector levers on the card:

¡     Before you install the card, release the ejector levers by pressing the spring clips.

¡     After the card is fully seated into slot, press the ejector levers inward until the spring clips lock it in place.

¡     Before you remove the card, release the ejector levers by pressing the spring clips.

·     This card can be used only with Type H interface cards, which have an H in their card identifiers (for example, LSXM1CGQ36HB1). This card cannot operate correctly if it is used with an interface card that is not Type H.

·     Only switching fabric modules of the same model can be installed on the same switch.


3  Related documentation

For module installation, see H3C S12500X-AF Switch Series Installation Guide.

For software upgrade, see the release notes for the device.



Copyright © 2018 New H3C Technologies Co., Ltd.

The information in this document is subject to change without notice.

Contact Sales