- Released At: 02-12-2020
- Page Views:
- Downloads:
- Table of Contents
- Related Documents
-
LSXM1CGQ36HB1 36-port 100G QSFP28 fiber interface card
1 Identifier
The card identifier LSXM1CGQ36HB1 is at the upper right corner of the front panel.
2 Specifications
CAUTION: This card can be used only with Type H switching fabric modules, which have a character string of SFH in their card identifiers (for example, LSXM1SFH16C1). Card damage will occur if this card is used with a switching fabric module that is not Type H. |
|
NOTE: Switching fabric module slots are covered by fan trays. To verify the card identifiers of the switching fabric modules while the switch is operating, use the display device command. |
Table 1 Card specifications
Item |
Specification |
Processor |
MIPS64 (Dual Core) @ 1.2 GHz |
SDRAM |
16 GB DDR3 SDRAM |
Power consumption |
608 W to 935 W |
Interfaces |
36 x QSFP28 ports |
Transmission rate |
100/40 Gbps |
Compatible device models |
H3C S12500X-AF switches (High-performance fan trays are required on all S12500X-AF switches except for the S12501X-AF.) |
Compatible switching fabric modules |
Type H switching fabric modules |
IMPORTANT: · To verify compatibility of the card with the software release you are using, see the release notes. · For information about transceiver modules and cables available for the module, see H3C S12500X-AF Switch Series Modules and Transceiver Modules Compatibility Matrixes. · If high-performance DDR memory is installed on the module (labelled with this installation information), see the release notes to verify the device software compatibility with the memory. |
3 Related documentation
For card installation, see H3C S12500X-AF Switch Series Installation Guide.
For software upgrade, see the release notes for the device.
Copyright © 2020 New H3C Technologies Co., Ltd.
The information in this document is subject to change without notice.