H3C LSEM3SUPA0 Card Manual-APW100

HomeSupportResource CenterSwitchesH3C S10500X-G Switch SeriesH3C S10500X-G Switch SeriesTechnical DocumentsInstall & UpgradeMPU Card ManualsH3C LSEM3SUPA0 Card Manual-APW100
Download Book
Title Size Downloads
H3C LSEM3SUPA0 Card Manual-APW100-book.pdf 37.83 KB
Table of Contents
Related Documents

H3C LSEM3SUPA0 interface module

1  Identifier

The module identifier LSEM3SUPA0 is in the upper left corner of the front panel.

2  About the module

Table 1 Module specifications

Item

Specification

Flash

2 GB

BootROM

32 MB

NVRAM

1 MB

SDRAM

8 GB

Dimensions (H × W × D)

45 × 208 × 269 mm (1.77 × 8.19 × 10.59 in)

Power consumption

22 W to 33 W

Interfaces

·     1 × console port

·     1 × USB port

·     2 × network management ports: 1 × RJ-45 ports and 1 × SFP fiber ports

Transmission rate

·     Console port: 9600 bps to 115200 bps ( default: 9600 bps )

·     network management ports ( RJ-45 ): 10/100/1000 Mbps, half/full duplex

·     network management ports ( SFP ): 1000 Mbps

Transmission medium and max transmission distance

·     Console port: 15 m ( 49.21 ft ) over asynchronous EIA/TIA-232 cables

·     network management ports ( RJ-45 ): 100 m ( 328.08 ft ) over Category 5 or higher twisted pair cables

·     network management ports ( SFP ): GE SFP fiber module specification

 

IMPORTANT

IMPORTANT:

·     To verify the compatibility of the module with the product models and software releases, see the release notes.

·     For information about transceiver modules and cables available for the module, see the modules and transceiver modules compatibility matrixes for the device.

·     Before connecting the SFP network management port, make sure the peer Ethernet port operates at 1000 Mbps in full duplex mode.

·     The USB port does not support USB extension cables.

 

The 10/100/1000BASE-T copper port uses an RJ-45 connector.

Figure 1 RJ-45 connector

 

Table 2 RJ-45 GE connector pinout

Pin

10BASE-T/100BASE-TX/1000BASE-T

Signal

Function

1

MX_0+

Transmits and receives data.

2

MX_0-

Transmits and receives data.

3

MX_1+

Transmits and receives data.

4

MX_2+

Transmits and receives data.

5

MX_2-

Transmits and receives data.

6

MX_1-

Transmits and receives data.

7

MX_3+

Transmits and receives data.

8

MX_3-

Transmits and receives data.

 

3  Related documentation

For information about module installation, see the installation guide for the device.

For software upgrade, see the release notes.

 

 

Copyright © 2022 New H3C Technologies Co., Ltd.

The information in this document is subject to change without notice.