国家 / 地区

单PoE DIMM条安装说明书(V1.00)

手册下载

99-整本手册.pdf  (90.29 KB)

PoE DIMM条安装说明书

规格说明

PoE DIMM条提供24端口PoE供电管理能力,适用的单板类型,请咨询客户工程师。

安装方式

请使用如下方式安装PoE DIMM条:

确认安装位置

将本PoE DIMM条插入接口板具有Master丝印标识的插槽。

注意事项

1)        在安装PoE DIMM条时,为了安全起见,请务必配带防静电手套或者防静电护腕。

2)        只有将PoE DIMM条正确插入槽位,PoE模块才能正常工作。

安装步骤

1)        从盒中取出PoE DIMM条。

2)        将其插入接口板上对应的DIMM槽位,并压紧启拔开关。

l      由于DIMM插槽已经设计为防反槽,因此用户无需担心会将PoE DIMM条安装方向插反。

l      PoE DIMM条只能在支持PoE的接口板上使用。

l      如果没插PoE DIMM条或者没有插紧PoE DIMM条,接口板无法进行远程供电,但其他业务可以正常工作。

 

 


Single PoE DIMM Module Installation Guide

Technical Specifications

This PoE DIMM module delivers the PoE management function on certain 24-port interface cards.

Installing the PoE DIMM Module

Follow these steps to install the PoE DIMM module:

Checking the Position of the Module

Insert the PoE DIMM module into the socket with the Master silkscreen on the interface card.

Precautions

l           For the sake of safety, make sure you wear an ESD-protective wrist strap or gloves when installing the PoE DIMM modules.

l           The PoE module can operate normally only if the PoE DIMM module is properly seated.

Installation Steps

l           Take out the PoE DIMM modules.

l           Insert the PoE DIMM module into the corresponding DIMM socket and close the locking spring clips until the pins at both ends of the clip snap into the notches in the module.

 

l      The reverse insertion prevention design of the DIMM socket ensures that you can insert the module in the right direction.

l      PoE DIMM modules are supported on PoE interface cards only.

l      If no PoE DIMM module is in place or the module is not fully seated, the interface card cannot supply power, though other functions go well.