Login
- Released At: 24-08-2023
- Page Views:
- Downloads:
- Table of Contents
- Related Documents
-
H3C ANT-2507P-S4 directional antenna installation guide
Technical specifications
The ANT-2507P-S4 dual-band directional Wi-Fi antenna is designed for use in indoor environments. It is connected to the device through RP-SMA male connectors.
Figure 1 Antenna view
Table 1 Technical specifications
|
Item |
ANT-2507P-S4 |
|
Frequency range |
· 2400 MHz to 2500 MHz · 5150 MHz to 5850 MHz |
|
Polarization type |
Horizontal and vertical |
|
Gain |
7 dBi |
|
Horizontal beamwidth (HBW) |
60 degrees |
|
Vertical beamwidth (VBW) |
35 degrees |
|
Impedance |
50 Ω |
|
Voltage standing wave ratio (VSWR) |
< 2.0 |
|
Maximum power |
20 W |
|
Connector |
RP-SMA-J |
|
Dimensions (H × W × D) |
35 × 229 × 229 mm (1.38 × 9.02 × 9.02 in) |
|
Weight (including the antenna casing) |
0.43 kg (0.95 lb) |
Figure 2 through Figure 5 show the horizontal and vertical radiation patterns.
Figure 2 2.4 GHz horizontal pattern
Figure 3 2.4 GHz vertical pattern
Figure 4 5 GHz horizontal pattern
Figure 5 5 GHz vertical pattern
Safety precautions
|
|
WARNING! · Installing antennas carries some level of risk. For your safety, read the following safety precautions carefully before your operation. · Keep the antenna away from power sources, street lamps, power distribution boxes, or other places that might cause electrical shock. · Do not touch any power lines for your safety. |
· Keep safety in mind when you select your installation site. Keep away from electric power lines and other lines.
· Do not work alone when you install the antenna.
· If the antenna, antenna cable, or any other installation accessory drops, get away from it to avoid bodily injury.
· To avoid any potential hazards, always have a professional handle power connection rather than attempting it yourself.
· If an accident, for example, electrical shock, occurs, immediately call for qualified emergency help.
Installation guidelines
To ensure optimal performance of the antenna, follow these guidelines:
· Keep the antenna away from metal obstacles, such as heating pipes and air conditioners.
· The material and thickness of walls determine the number of walls that the RF signal can penetrate. 5 GHz signal attenuation is large. Avoid signal penetration through solid walls.
Mounting the antenna
1. Put the antenna over the AP front.
2. Use M2.6 × 6 mm screws to secure the antenna.
3. Connect the RP-SMA male connectors on the antenna to the RP-SMA female connectors on the AP.
Figure 6 Mounting the antenna
