Login
- Table of Contents
-
- 04-Layer 2—LAN Switching Configuration Guide
- 00-Preface
- 01-MAC address table configuration
- 02-Ethernet link aggregation configuration
- 03-M-LAG configuration
- 04-Port isolation configuration
- 05-VLAN configuration
- 06-MVRP configuration
- 07-QinQ configuration
- 08-VLAN mapping configuration
- 09-Loop detection configuration
- 10-Spanning tree configuration
- 11-LLDP configuration
- 12-L2PT configuration
- 13-Service loopback group configuration
- 14-PFC configuration
- Related Documents
-
| Title | Size | Download |
|---|---|---|
| 13-Service loopback group configuration | 51.45 KB |
Configuring service loopback groups
Restrictions: Hardware compatibility with service loopback group
Restrictions and guidelines: Service loopback group configuration
Configuring a service loopback group
Display and maintenance commands for service loopback groups
Configuring service loopback groups
About service loopback groups
Restrictions: Hardware compatibility with service loopback group
Only SD interface modules, SF interface modules, and ports on the SC MPUs prefixed with LSCM2 support the service loopback group feature.
A device supports service loopback groups only when it operates in expert mode. For more information about device operating modes, see device management configuration in Fundamentals Configuration Guide.
Restrictions and guidelines: Service loopback group configuration
When you apply service loopback groups to features, follow these restrictions and guidelines:
· You can apply a service loopback group to other features once the group is created. The service loopback group will process services for the features.
· Do not delete a service loopback group that is being used by a feature.
Configuring a service loopback group
1. Enter system view.
system-view
2. Create a service loopback group and specify its service type.
service-loopback group group-id type vsi-gateway
You can configure only one service loopback group for a service type.
Display and maintenance commands for service loopback groups
Execute display commands in any view.
|
Task |
Command |
|
Display information about service loopback groups. |
display service-loopback group [ group-id ] |