Login
- Released At: 31-10-2021
- Page Views:
- Downloads:
- Table of Contents
- Related Documents
-
LSXM1SUP04T2 supervisor engine unit
1 Identifier
The module identifier LSXM1SUP04T2 is in the upper right corner of the front panel.
2 About the module
Table 1 Module specifications
|
Item |
Specification |
|
Processor |
Quad-Core @ 2.2 GHz |
|
SDRAM |
16 GB |
|
Flash |
8 GB |
|
NVRAM |
512 KB |
|
Power consumption |
24 W to 35 W |
|
Interfaces |
· 1 × console port · 1 × USB port ( USB 2.0, Host port ) · 2 × network management ports: 1 × RJ-45 ports and 1 × SFP fiber ports |
|
Transmission rate |
· Console port: 9600 bps to 115200 bps ( default: 9600 bps ) · network management ports ( RJ-45 ): 10/100/1000 Mbps, half/full duplex · network management ports ( SFP ): 1000 Mbps |
|
Transmission medium and max transmission distance |
· Console port: 15 m ( 49.21 ft ) over asynchronous EIA/TIA-232 cables · network management ports ( RJ-45 ): 100 m ( 328.08 ft ) over Category 5 or higher twisted pair cables · network management ports ( SFP ): GE SFP fiber module specification |
|
|
IMPORTANT: · This module can be used only with Type T fabric modules (such as LSXM1SFT04F2) and Type T interface modules (such as LSXM1TGS48TE2). · To verify the compatibility of the module with the software release you are using, see the release notes. · For information about transceiver modules and cables available for the module, see the cards and transceiver modules compatibility matrixes for the device. · The USB port outputs power as prescribed by USB 2.0. For the USB port to identify the USB device, use only a USB device fully compliant with USB 2.0. · Set the same speed and duplex mode for a management Ethernet interface and its peer port. · To transfer files from the BootWare menu, you can use only the 10/100/1000BASE-T management port (M0/0/0). The SFP port (M0/0/1) cannot be used for file transfer from the BootWare menu. |
The 10/100/1000BASE-T copper port uses an RJ-45 connector.
Figure 1 RJ-45 connector
Table 2 RJ-45 GE connector pinout
|
Pin |
10BASE-T/100BASE-TX/1000BASE-T |
|
|
Signal |
Function |
|
|
1 |
MX_0+ |
Transmits and receives data. |
|
2 |
MX_0- |
Transmits and receives data. |
|
3 |
MX_1+ |
Transmits and receives data. |
|
4 |
MX_2+ |
Transmits and receives data. |
|
5 |
MX_2- |
Transmits and receives data. |
|
6 |
MX_1- |
Transmits and receives data. |
|
7 |
MX_3+ |
Transmits and receives data. |
|
8 |
MX_3- |
Transmits and receives data. |
3 Related documentation
For information about module installation, see the installation guide for the device.
For software upgrade, see the release notes.
Copyright © 2020-2021 New H3C Technologies Co., Ltd.
The information in this document is subject to change without notice.
