Perform this task to view and edit cluster parameters.
On the top navigation bar, click System, and then select Parameters > Cluster Parameters from the navigation pane.
Select a cluster from the Cluster list.
You can edit the default gateway and shared file system heartbeat network for the UIS hyper-converged management platform.
Basic Info
Cluster Type: Type of the cluster you have selected when the cluster is initialized or created.
Host Name: Common part of names of the hosts managed by the UIS cluster.
Numbering From: Start number of names of the hosts managed by the UIS cluster.
Management:
Start IP: Start IP address and mask length of the management network.
Gateway: Default gateway for the selected management network. It is also the management network gateway for all hosts in the cluster.
VLAN ID: VLAN to which the management network belongs.
Storage Management IP: IP address of the distributed storage management node.
Storage Front-End:
Start IP: Start IP address and mask length of the storage front-end network.
VLAN ID: VLAN to which the storage front-end network belongs.
Storage Back-End:
Start IP: Start IP address and mask length of the storage back-end network.
VLAN ID: VLAN to which the storage back-end network belongs.
Shared File System Heartbeat Network—Configure the network segment where the heartbeat network for the shared file system of the hosts in the cluster resides. The storage front-end network is used as the shared file system heartbeat network by default. You can select a network as the shared file system heartbeat network based on the storage device used by the hosts, available NICs, and management network or storage front-end network bandwidth.
IP Address: Enter an IP address within the network segment where the shared file system heartbeat network resides. Assume that management network 192.168.10.0/24, service network 192.168.20.0/24, storage back-end network 192.168.30.0/24, and storage front-end network 192.168.40.0/24 are configured on a host. To use the management network as the shared file system heartbeat network, you can set the IP address to an IP address in 192.168.10.0/24, 192.168.10.8 for example. If you do not specify any IP address, the storage front-end network is used as the shared file system heartbeat network.