Configure a WST encryption module

Prerequisites

• Configure the encryption module according to the manufacturer's instructions and ensure the network connectivity between the encryption module and the system.

• Obtain the IP address and port information of the encryption module in advance.

Configure encryption module

1. On the top navigation bar, click System.

2. From the left navigation pane, select System Settings > Security Settings > Encryption Module Settings.

3. Configure parameters for the encryption module. Click Save Configuration or Edit.

Table-1 Configuring encryption module parameters

Parameter	Description
Encryption Module IP/Port	Enter the obtained encryption module IP or port.
Encryption Key	Set the encryption key for encryption as required by the manufacturer.
Encryption Module Manufacturer	Specify the encryption module manufacturer as WST.
Key Password	Set the key password. This filed is optional. If you do not set a key password, the system uses the default key password 11111111.

 

Start encryption

1. On the top navigation bar, click System.

2. From the left navigation pane, select System Settings > Security Settings > Encryption Module Settings.

3. Click Start Encryption.