Change the network mode

After deploying UIS-Sec management component VMs and UIS-Sec gateway component VMs, you can switch the network mode to advanced.

Restrictions and guidelines

If you no longer use the UIS-Sec management component, enable basic network mode.

Procedure

1. On the top navigation bar, click Network.

2. From the left navigation pane, select Advanced Network Management > Network Mode Management.

Figure-1 Network mode management

 

3. Select the advanced network mode, and then configure the parameters.

4. Click Save.

5. The configuration takes effect at the next login.

Parameters

• IP Address: Enter the IP address of the advanced network management platform.

• Username: Enter the username for accessing the advanced network management platform. The default username is admin.

• Password: Enter the password of the username. The default password is Cloud@1234.