On UIS Cloud, click Cloud Services on the top navigation bar. On the UIS-Sec portal of UIS Manager Standard Edition, click Network Services on the top navigation bar.
From the left navigation pane, select Network & Security > Firewalls.
Click the Rules tab, and then click Create.
Configure the rule parameters as described in "Parameters."
Click Create.
On UIS Cloud, click Cloud Services on the top navigation bar. On the UIS-Sec portal of UIS Manager Standard Edition, click Network Services on the top navigation bar.
From the left navigation pane, select Network & Security > Firewalls.
Click Import.
Click Download Template to download a template. Configure the rule parameters in the template as described in "Parameters."
Click Select File to select the template file.
Select the rules to be imported, and then click OK.
Name: Name of the rule.
Match Mode: Packet matching mode of the rule. A firewall filters packets based on the five-tuple information of the packets or an object group.
Action: Action (permit or deny) to be taken on the traffic matching the rule.
Protocol: Matching protocol of the rule. At present, TCP, UDP, and ICMP are supported. If you select ANY, the rule matches all supported protocols.
Source IP: Source IP address of the traffic.
Source Port: Source port of the TCP or UDP connection. This field is available only when the protocol is TCP or UDP.
Destination IP: Destination IP address of the traffic.
Destination Port: Destination port of the TCP or UDP connection. This field is available only when the protocol is TCP or UDP.