Manage iSER HA
|
|
If the storage cluster uses the iSCSI protocol, configure iSCSI HA. |
iSER HA management allows you to set an HA VIP for the storage front-end network that provides storage service for the storage cluster to ensure service continuity. The clients can discover the block devices in the storage cluster by accessing the iSER HA VIP, without being affected by storage node failure.
Restrictions and guidelines
Specify the primary and backup nodes, which form an iSER HA group, for iSER access when you add an iSER HA VIP. To avoid service interruption, make sure the routing information for all nodes in the iSER HA group is the same.
Before deleting an iSER HA VIP, disconnect the clients that use the VIP.
Editing an iSER HA group will cause the HA IP address of iSER block storage to be unavailable. Clients cannot access the block storage resources of the cluster at the HA IP address. Before editing an iSER HA group, perform the following tasks:
Stop the services provided by the iSER HA group.
To prevent service interruption, configure routing to ensure the nodes in the same iSER HA group can reach one another at Layer 3.
Verify that the iSER HA group is no longer needed.
Disabling an iSER HA group will disable the client group from accessing the block storage resources and cause service interruption. Before disabling an iSER HA group, perform the following tasks:
Stop the services provided by the iSER HA group.
Verify that the iSER HA group is no longer needed.
Add an iSER HA VIP
On the top navigation bar, click Storage.
Select Block Device > Mapping Management from the navigation pane.
Click the iSER HA tab.
Select a cluster from the Cluster list in the upper right corner of the page if multiple clusters exist in the system.
Click Add.
Configure the parameters as described in "Parameters."
Edit an iSER HA VIP
On the top navigation bar, click Storage.
Select Block Device > Mapping Management from the navigation pane.
Click the iSER HA tab.
Select a cluster from the Cluster list in the upper right corner of the page if multiple clusters exist in the system.
Select an HA VIP, and then click the
icon for the HA VIP.
Edit the parameters as described in "Parameters."
Delete an iSER HA VIP
On the top navigation bar, click Storage.
Select Block Device > Mapping Management from the navigation pane.
Click the iSER HA tab.
Select a cluster from the Cluster list in the upper right corner of the page if multiple clusters exist in the system.
Select an HA VIP, and then click the
icon for the HA VIP.
In the dialog box that opens, click OK.
Enable an iSER HA VIP
On the top navigation bar, click Storage.
Select Block Device > Mapping Management from the navigation pane.
Click the iSER HA tab.
Select a cluster from the Cluster list in the upper right corner of the page if multiple clusters exist in the system.
Select an HA VIP, and then click the
icon for the HA VIP.
In the dialog box that opens, click OK.
Disable an iSER HA VIP
On the top navigation bar, click Storage.
Select Block Device > Mapping Management from the navigation pane.
Click the iSER HA tab.
Select a cluster from the Cluster list in the upper right corner of the page if multiple clusters exist in the system.
Select an HA VIP, and then click the
icon for the HA VIP.
In the dialog box that opens, click OK.
Parameters
HA VIP: Enter the IP address for users to access the block devices in the storage cluster through iSER. It must belong to the storage front-end network.
HA Group ID: Enter the ID of the iSER HA group. This ID will be issued to all nodes in the group. Only nodes with the same HA group ID can perform HA VIP switchover.
Primary Node IP: Select the storage front-end network IP for access through iSER.