Perform this task to view and edit cluster parameters.
On the top navigation bar, click System, and then select Parameters > Cluster Parameters from the navigation pane.
Select a cluster from the Cluster list on top of .
You can edit the default gateway and shared file system heartbeat network for the UIS hyper-converged management platform.
Basic Info
Cluster Type: Type of the cluster you have selected when the cluster is initialized or created.
Host Name: Common part of names of the hosts managed by the UIS cluster.
Numbering From: Start number of names of the hosts managed by the UIS cluster.
Management:
Start IP: Start IP address and mask length of the management network.
Gateway: Default gateway for the selected management network. It is also the management network gateway for all hosts in the cluster.
VLAN ID: VLAN to which the management network belongs.
Storage Management IP: IP address of the distributed storage management node.
Storage Front-End:
Start IP: Start IP address and mask length of the storage front-end network.
VLAN ID: VLAN to which the storage front-end network belongs.
Storage Back-End:
Start IP: Start IP address and mask length of the storage back-end network.
VLAN ID: VLAN to which the storage back-end network belongs.
Shared File System Heartbeat Network—Configure the network segment where the heartbeat network for the shared file system of the hosts in the cluster resides. For two-node deployment, the storage front-end network is used as the shared file system heartbeat network by default. For deployment of three or more nodes, the management network of the host is used as the shared file system heartbeat network by default. You can select a network as the shared file system heartbeat network based on the storage device used by the hosts, available NICs, and management network or storage front-end network bandwidth.
IP Address: Enter an IP address within the network segment where the shared file system heartbeat network resides. Assume that management network 192.168.10.0/24, service network 192.168.20.0/24, storage back-end network 192.168.30.0/24, and storage front-end network 192.168.40.0/24 are configured on a host in three-node deployment. To use the storage front-end network as the shared file system heartbeat network, you can set the IP address to an IP address in 192.168.40.0/24, 192.168.40.8 for example. If you do not specify any IP address, the management network is used as the shared file system heartbeat network.