- Released At: 31-10-2021
- Page Views:
- Downloads:
- Table of Contents
- Related Documents
-
LSXM2SFT08E2 switching fabric module
1 Card identifier
The card identifier LSXM2SFT08E2 is at the upper right corner of the front panel.
2 Specifications
Table 1 Card specifications
Item |
Specification |
Processor |
Processor (dual-core) @ 1.6 GHz |
SDRAM |
4 GB |
Power consumption |
153 W to 223 W |
CAUTION: Do not install switching fabric modules of different models on the same switch. |
IMPORTANT: · This module can be used only with Type T supervisor engine units (such as LSXM2SUPT2) and Type T interface modules (such as LSXM1TGS48TE2). · To verify the compatibility of the module with the software release you are using, see the release notes. · Remove the protection box from the card before you install the card. · You must install the cards before you install the fan trays, and remove the fan trays before you remove the cards. · Follow these instructions to use the ejector levers on the card: ¡ Before you install the card, release the ejector levers by pressing the spring clips. ¡ After the card is fully seated into slot, press the ejector levers inward until the spring clips lock it in place. ¡ Before you remove the card, release the ejector levers by pressing the spring clips. |
3 Obtaining documentation
For information about module installation, see the installation guide for the device.
For software upgrade, see the release notes for the device.
Copyright © 2020-2021 New H3C Technologies Co., Ltd.
The information in this document is subject to change without notice.