- Released At: 05-03-2020
- Page Views:
- Downloads:
- Table of Contents
- Related Documents
-
1 Identifier
The module identifier LSQM1SRP4Y06A0 is in the upper right corner of the front panel.
2 Specifications
Table 1 Card specifications
Item |
Specification |
Flash |
2 GB |
BootROM |
8 MB |
NVRAM |
1 MB |
SDRAM |
4 GB |
Card size (H × W × D) |
45 × 399 × 355 mm (1.77 × 15.71 × 13.98 in) |
Power consumption |
37 W to 62 W |
Interfaces |
· 1 console port · 1 USB console port · 2 network management ports: 1 RJ-45 ports and 1 SFP fiber ports · 1 primary USB port · 4 × 25GBASE-R-SFP28 fiber ports |
Transmission rate |
· Console port: 9600 bps to 115200 bps (default: 9600 bps) · USB console port: ≤ 115200 bps (default: 9600 bps) · network management ports ( RJ-45 ): 10/100/1000 Mbps, half/full duplex · network management ports (SFP ): 1000 Mbps · 25GBASE-R-SFP28 fiber ports: 10 Gbps/25 Gbps |
Transmission medium and max transmission distance |
· Console port: 15 m (49.21 ft) over asynchronous EIA/TIA-232 cables · USB console port: 10 m (32.81 ft) over USB-AB cables · network management ports ( RJ-45 ): 100 m (328.08 ft) over Category 5 or higher twisted pair cables |
Compatible device models |
S7506X/S7506X-PoE/S7506X-S |
|
NOTE: · H3C recommends not using a USB extender cable to connect the USB port. · For more information about transceiver modules and cables available for the card, see H3C S7500X Switch Series Cards and Transceiver Modules Compatibility Matrixes. · To verify compatibility of the module with the software release you are using, see the release notes. |
The 10/100/1000BASE-T copper port uses an RJ-45 connector.
Figure 1 RJ-45 connector
Table 2 RJ-45 GE connector pinout
Pin |
10BASE-T/100BASE-TX/1000BASE-T |
|
Signal |
Function |
|
1 |
MX_0+ |
Transmits and receives data. |
2 |
MX_0- |
Transmits and receives data. |
3 |
MX_1+ |
Transmits and receives data. |
4 |
MX_2+ |
Transmits and receives data. |
5 |
MX_2- |
Transmits and receives data. |
6 |
MX_1- |
Transmits and receives data. |
7 |
MX_3+ |
Transmits and receives data. |
8 |
MX_3- |
Transmits and receives data. |
3 Related documentation
For module installation, see H3C S7500X Switch Series Installation Guide.
For software upgrade, see the release notes.
Copyright © 2020 New H3C Technologies Co., Ltd.
The information in this document is subject to change without notice.