LSQM1SRP4Y06A0 Card Manual-APW100

HomeSupportResource CenterSwitchesH3C S7500X Switch SeriesH3C S7500X Switch SeriesTechnical DocumentsInstallCard Module ManualsLSQM1SRP4Y06A0 Card Manual-APW100
Download Book
Title Size Downloads
LSQM1SRP4Y06A0 Card Manual-APW100-book.pdf 71.36 KB
Table of Contents
Related Documents

MPU—LSQM1SRP4Y06A0

1  Identifier

The module identifier LSQM1SRP4Y06A0 is in the upper right corner of the front panel.

2  Specifications

Table 1 Card specifications

Item

Specification

Flash

2 GB

BootROM

8 MB

NVRAM

1 MB

SDRAM

4 GB

Card size (H × W × D)

45 × 399 × 355 mm (1.77 × 15.71 × 13.98 in)

Power consumption

37 W to 62 W

Interfaces

·         1 console port

·         1 USB console port

·         2 network management ports: 1 RJ-45 ports and 1 SFP fiber ports

·         1 primary USB port

·         4 × 25GBASE-R-SFP28 fiber ports

Transmission rate

·         Console port: 9600 bps to 115200 bps (default: 9600 bps)

·         USB console port: ≤ 115200 bps (default: 9600 bps)

·         network management ports ( RJ-45 ): 10/100/1000 Mbps, half/full duplex

·         network management ports  (SFP ): 1000 Mbps

·         25GBASE-R-SFP28 fiber ports: 10 Gbps/25 Gbps

Transmission medium and max transmission distance

·         Console port: 15 m (49.21 ft) over asynchronous EIA/TIA-232 cables

·         USB console port: 10 m (32.81 ft) over USB-AB cables

·         network management ports ( RJ-45 ): 100 m (328.08 ft) over Category 5 or higher twisted pair cables

Compatible device models

S7506X/S7506X-PoE/S7506X-S

 

 

NOTE:

·      H3C recommends not using a USB extender cable to connect the USB port.

·      For more information about transceiver modules and cables available for the card, see H3C S7500X Switch Series Cards and Transceiver Modules Compatibility Matrixes.

·      To verify compatibility of the module with the software release you are using, see the release notes.

 

The 10/100/1000BASE-T copper port uses an RJ-45 connector.

Figure 1 RJ-45 connector

 

Table 2 RJ-45 GE connector pinout

Pin

10BASE-T/100BASE-TX/1000BASE-T

Signal

Function

1

MX_0+

Transmits and receives data.

2

MX_0-

Transmits and receives data.

3

MX_1+

Transmits and receives data.

4

MX_2+

Transmits and receives data.

5

MX_2-

Transmits and receives data.

6

MX_1-

Transmits and receives data.

7

MX_3+

Transmits and receives data.

8

MX_3-

Transmits and receives data.

 

3  Related documentation

For module installation, see H3C S7500X Switch Series Installation Guide.

For software upgrade, see the release notes.

 

Copyright © 2020 New H3C Technologies Co., Ltd.

The information in this document is subject to change without notice.