H3C S12500X-AF LSXM1SUPE1 Card Manual-APW101

HomeSupportResource CenterSwitchesH3C S12500X-AF Switch SeriesH3C S12500X-AF Switch SeriesTechnical DocumentsInstallCard Module ManualsH3C S12500X-AF LSXM1SUPE1 Card Manual-APW101
Download Book
Table of Contents
Related Documents

LSXM1SUPE1 supervisor engine unit

1  Identifier

The card identifier LSXM1SUPE1 is at the upper right corner of the front panel.

2  Specifications

Table 1 Card specifications

Item

Specification

Processor

Intel processor (Quad Core) @ 2.2 GHz

DDR

32GB DDR4 (two DIMM slots)

Flash

4GB EMMC

NVRAM

512 KB

SSD

240 GB (SATA)

Power consumption

52 W to 70 W

Connector

·         RJ-45

·         LC

·         USB (Type A)

·         Mini-USB (Type AB)

Interfaces

·         1 × RJ-45 console port

·         1 × mini-USB console port

·         2 × 10/100/1000BASE-T ports for management and upgrade

·         2 × SFP ports for management and upgrade

·         1 × USB port (USB 3.0, Host port)

·         2 × 1PPS/ToD time synchronization ports

·         2 × SMB clock input ports

·         2 × SMB clock output ports

Transmission rate

·         Console port: 9600 bps (default) to 115200 bps

·         10/100/1000BASE-T port: 10/100/1000 Mbps

·         SFP port: 1000 Mbps

Transmission medium and max transmission distance of the console port

15 m (49.21 ft) over asynchronous serial cable

Transmission medium and max transmission distance of the 10/100/1000BASE-T port

100 m (328.08 ft) over category-5 UTP

Compatible device models

S12516X-AF/S12512X-AF/S12508X-AF

 

IMPORTANT

IMPORTANT:

·      To verify compatibility of the card with the software release you are using, see the release notes.

·      You can access and configure the device through the RJ-45 console port or the mini-USB console port. Only one port is active at a time.

·      To connect a USB device to the card, make sure the USB device is in good condition.

·      Set the same speed and duplex mode for a management Ethernet interface and its peer port.

·      If multiple management ports are connected to one remote switch, you must assign their peer ports to different VLANs on the remote switch. Login or file transfer will fail if the peer ports are in the same VLAN.

·      To transfer files from the BootWare menu through TFTP or FTP, you can use only the management port M0/0/3. This port is marked with a number of 3 on the card panel.

·      For information about transceiver modules and cables available for the card, see H3C S12500X-AF Switch Series Cards and Transceiver Modules Compatibility Matrixes.

 

3  Related documentation

For module installation, see the H3C S12500X-AF Switch Series Installation Guide.

For software upgrade, see the release notes for the device.

 

 

Copyright © 2020 New H3C Technologies Co., Ltd.

The information in this document is subject to change without notice.