H3C S12500R LSXM1SUPER1 Card Manual-APW100

HomeSupportResource CenterSwitchesH3C S12500R Switch Router SeriesH3C S12500R Switch Router SeriesTechnical DocumentsInstallCard Module ManualsH3C S12500R LSXM1SUPER1 Card Manual-APW100
Download Book
Table of Contents
Related Documents

LSXM1SUPER1 supervisor engine unit

1  Identifier

The module identifier LSXM1SUPER1 is in the upper right corner of the front panel.

2  Specifications

Table 1 Module specifications

Item

Specification

Processor

Intel processor (Quad Core) @ 2.2 GHz

DDR

32GB DDR4 (two DIMM slots)

Flash

4GB EMMC

NVRAM

512 KB

SSD

240 GB (SATA)

Power consumption

52 W to 70 W

Connector

·         RJ-45

·         LC

·         USB (Type A)

·         Mini-USB (Type AB)

Interfaces

·         1 × RJ-45 console port

·         1 × mini-USB console port

·         2 × 10/100/1000BASE-T ports for management and upgrade

·         2 × GE SFP ports for management and upgrade

·         1 × USB port (USB 3.0, Host port)

·         2 × 1PPS/ToD time synchronization ports

·         2 × SMB clock input ports

·         2 × SMB clock output ports

Transmission rate

·         Console port: ≤ 115200 bps (default: 9600 bps)

·         10/100/1000BASE-T port: 10/100/1000 Mbps

·         SFP port: 1000 Mbps

Transmission medium and max transmission distance of the console port

15 m (49.21 ft) over an asynchronous serial cable

Transmission medium and max transmission distance of the 10/100/1000BASE-T port

100 m (328.08 ft) over a category-5 twisted pair cable

Compatible device models

S12516R switch router

S12508R switch router

 

IMPORTANT

IMPORTANT:

·      To verify compatibility of the module with the software release you are using, see the release notes.

·      You can access and configure the device through the RJ-45 console port or the mini-USB console port. Only one port is active at a time.

·      To connect a USB device to the module, make sure the USB device is in good condition.

·      Set the same speed and duplex mode for a management Ethernet port and its peer port.

·      If multiple management ports are connected to one remote switch, you must assign their peer ports to different VLANs on the remote switch. Login or file transfer will fail if the peer ports are in the same VLAN.

·      To transfer files from the BootWare menu through TFTP or FTP, you can use only the management port M0/0/3.

·      For information about transceiver modules and cables available for the module, see H3C S12500R Switch Router Series Cards and Transceiver Modules Compatibility Matrixes.

 

3  Related documentation

For module installation, see the H3C S12500R Switch Router Series Installation Guide.

For software upgrade, see the release notes for the device.

 

 

Copyright © 2020 New H3C Technologies Co., Ltd.

The information in this document is subject to change without notice.