H3C S12500R-2L LSXM1SUP02LR1 Card Manual-APW100

HomeSupportResource CenterSwitchesH3C S12500R Switch Router SeriesH3C S12500R Switch Router SeriesTechnical DocumentsInstallCard Module ManualsH3C S12500R-2L LSXM1SUP02LR1 Card Manual-APW100
Download Book
Table of Contents
Related Documents

LSXM1SUP02LR1 supervisor engine unit

1  Identifier

The module identifier LSXM1SUP02LR1 is in the upper right corner of the front panel.

2  Specifications

Table 1 Module specifications

Item

Specification

Processor

Intel processor (Quad-Core) @ 2.2 GHz

SDRAM

16 GB DDR4 SDRAM (installed in one of the two DIMM slots)

Flash

8 GB EMMC

NVRAM

512 KB

Power consumption

28 W to 35 W

Connector

·         RJ-45

·         LC

·         USB (Type A)

Ports

·         1 × console port

·         1 × 10/100/1000BASE-T port for management and upgrade

·         1 × GE SFP port for management and upgrade

·         1 × USB port (USB 2.0, Host port)

Transmission rate

·         Console port: ≤ 115200 bps (default: 9600 bps)

·         10/100/1000BASE-T port: 10/100/1000 Mbps

·         SFP port: 1000 Mbps

Transmission medium and max transmission distance of the console port

15 m (49.21 ft) over an asynchronous serial cable

Transmission medium and max transmission distance of 10/100/1000BASE-T port

100 m (328.08 ft) over a category-5 twisted pair cable

Compatible device models

S12500R-2L switch router

 

IMPORTANT

IMPORTANT:

·      To verify compatibility of the module with the software release you are using, see the release notes.

·      The USB port outputs power as prescribed by USB 2.0. You can only install a USB 2.0-compliant device to the USB port.

·      Set the same speed and duplex mode for a management Ethernet port and its peer port.

·      If you connect the two management ports to the same remote switch, you must assign their peer ports to different VLANs on the remote switch. Login or file transfer will fail if the peer ports are in the same VLAN.

·      To transfer files from the BootWare menu through TFTP or FTP, you can use only the 10/100/1000BASE-T management port (M0/0/1).

·      For information about transceiver modules and cables available for the module, see H3C S12500R Switch Router Series Cards and Transceiver Modules Compatibility Matrixes.

 

3  Related documentation

For module installation, see H3C S12500R-2L Switch Router Installation Guide.

For software upgrade, see the release notes for the device.

 

 

Copyright © 2020 New H3C Technologies Co., Ltd.

The information in this document is subject to change without notice.