- Released At: 29-12-2022
- Page Views:
- Downloads:
- Table of Contents
- Related Documents
-
H3C CR-19K-LPU-XP40 Ethernet optical interface module
1 Identifier
The module identifier CR-19K-LPU-XP40 is on the far right of the front panel.
2 About the module
The CR-19K-LPU-XP40 40-port 10G Ethernet optical interface module can offer bidirectional line-rate forwarding at 400 Gbps. It provides 40 SFP+ Ethernet fiber ports. Each port is a Layer 3 interface and supports varieties of features, including IP routing, IP forwarding, MPLS, security, QoS, multicast, traffic statistics, and IPv6.
Figure 1 Front panel
(1) Port type label (10GBASE-R/W-SFP+) |
(2) 10GBASE-R/W-SFP+ ports and LEDs 1 to 40 |
(3) Running status LED (RUN) |
(4) Module identifier (CR-19K-LPU-XP40) |
Table 1 Module specifications
Item |
Specifications |
Ports |
40 × 10GBASE-R/W-SFP+ ports |
Dimensions (H × W × D) |
50 × 433 × 520 mm (1.97 × 17.05 × 20.47 in) |
Connector type |
LC |
Interface transmission rate |
· LAN mode: 10.3125 Gbps · WAN mode: 9.95328 Gbps |
Fiber port property |
Depends on the SFP+ transceiver module installed |
Power consumption |
595 W |
Hot swapping |
Supported |
IMPORTANT: · To verify compatibility of the module with the software release you are using, see the release notes. · For compatibility between the router and the interface module, see hardware information and specifications for the router. · For the transceiver modules and cables available for the interface module, see H3C CR19000 Core Routers Modules and Transceivers Compatibility Matrixes. |
Copyright © 2022 New H3C Technologies Co., Ltd.
The information in this document is subject to change without notice.