- Released At: 13-12-2022
- Page Views:
- Downloads:
- Table of Contents
- Related Documents
-
H3C CR-HIC-XP12 Ethernet optical interface card
1 Identifier
The module identifier CR-HIC-XP12 is in the upper right corner of the front panel.
2 About the module
The CR-HIC-XP12 10G Ethernet optical interface card provides 12 SFP+ ports and supports 10G SFP+ transceiver modules.
You can configure the 10G ports on the interface card to operate in LAN or WAN mode.
Figure 1 Front panel
(1) Port type label (10GBASE-R/W-SFP+) |
(2) Module identifier (CR-HIC-XP12) |
(3) 10GBASE-R/W-SFP+ ports and LEDs 1 to 12 |
Table 1 Module specifications
Item |
Specifications |
Dimensions (H × W × D) |
21 × 195 × 162 mm (0.83 × 7.68 × 6.38 in) |
Power consumption |
55 W |
Ports |
12 × 10GBASE-R/W-SFP+ ports |
Connector type |
LC |
Port rate |
· LAN mode: 10.3125 Gbps · WAN mode: 9.95328 Gbps |
Hot swapping |
Supported |
Port property |
Depends on the SFP+ transceiver module installed. |
IMPORTANT: · To verify compatibility of the module with the software release you are using, see the release notes. · For interface card compatibility with the interface modules, see the hardware information and specifications for the device. · For the transceiver modules and cables available for the interface card, see H3C CR19000 Core Routers Modules and Transceivers Compatibility Matrixes. |
Copyright © 2022 New H3C Technologies Co., Ltd.
The information in this document is subject to change without notice.