设置接口类型并划分到指定VLAN

# 配置连接防火墙的二层以太网接口GigabitEthernet1/0/7为Trunk端口，并允许VLAN10和VLAN20通过当前Trunk端口。

[PoE switch] interface gigabitethernet 1/0/7

[PoE switch-GigabitEthernet1/0/7] port link-type trunk

[PoE switch-GigabitEthernet1/0/7] port trunk permit vlan 10 20

[PoE switch-GigabitEthernet1/0/7] quit

# 配置连接AP的多个二层以太网接口（本例仅GE1/0/4）为Access端口，并将Access端口加入到指定的VLAN 10。

[PoE switch] interface gigabitethernet 1/0/4

[PoE switch-GigabitEthernet1/0/4] port link-type access

[PoE switch-GigabitEthernet1/0/4] port access vlan 10

[PoE switch-GigabitEthernet1/0/4] quit

# 配置连接RADIUS服务器的二层以太网接口GE1/0/6为Access端口，并将Access端口加入到指定的VLAN 10。

[PoE switch] interface gigabitethernet 1/0/6

[PoE switch-GigabitEthernet1/0/6] port link-type access

[PoE switch-GigabitEthernet1/0/6] port access vlan 10

[PoE switch-GigabitEthernet1/0/6] quit