H3C S9500 LSB1XP4LDB0 Card Manual(V1.01)
>

Table of Contents

                                                                      4端口10GBASE-R/W XFP光接口板 – LSB1XP4LDB0

1  单板标识

前面板右上角分别标有丝印：XP4LDB，用来标识该单板。

2  单板简介

                                                                                                                                                                                  表1 单板属性

属性

规格

接口连接器类型

XFP/LC

接口数量

4

接口传输速率

10Gbps

单板适用的机型

S9502/S9505/S9508/S9508V/S9512

 

可选用的XFP模块类型及其属性见下表。

                                                                                                                                                                            表2 XFP模块属性

XFP模块名称

中心波长

XFP模块提供的用户接口连接器类型

接口光纤规格

光纤最大传输距离

10GBase-SR/SW-XFP

850nm

LC

50/125µm多模光纤

对于62.5um MMF w/ 160MHz*km光纤，最大传输距离26M；

对于50um MMF w/ 500MHz*km光纤，最大传输距离82M；

对于50um MMF w/ 2000MHz*km光纤，最大传输距离300M；

10GBase-LR/LW-XFP

1310nm

9/125µm单模光纤

10km

10GBase-ER/EW-XFP

1550nm

9/125µm单模光纤

40km

 

3  注意事项

如主机软件版本不匹配，请联系该设备的销售商或集成商获取相应的主机软件版本；

单板安装说明及主机软件版本的升级方法请参见《H3C S9500系列路由交换机  安装手册》相关章节。

单板种类或规格可能随产品版本的变更而改变，请从公司网站http://www.h3c.com.cn主页上的“文档中心”获取最新资料。

 

 

杭州华三通信技术有限公司

 


                                         4-Port 10GBASE-R/W XFP Optical Interface Card – LSB1XP4LDB0

1  Card Identifier

The silkscreen XP4LDB is printed at the upper right corner of the front panel, and is used to identify the card.

2  Specifications

Table1  Card specifications

Item

Specification

Connector

XFP/LC

Port quantity

4

Transmission rate

10Gbps

Applied to

S9502/S9505/S9508/S9508V/S9512

 

For supported XFP modules, refer to the following table.

Table2  XFP Module Attribute

XFP module

Central wavelength

Connector

Matching cable

Transmission segment

10GBase-SR/SW-XFP

850 nm

LC

50/125 µm multimode optical fiber cable

For 62.5um MMF w/ 160MHz*km optical fiber cable: 26M;

For 50um MMF w/ 500MHz*km optical fiber cable: 82M;

For 50um MMF w/ 2000MHz*km optical fiber cable: 300M;

10GBase-LR/LW-XFP

1310 nm

9/125 µm single mode optical fiber cable

10 km (6 mi)

10GBase-ER/EW-XFP

1550 nm

9/125 µm single mode optical fiber cable

40 km (about 25 mi)

 

3  Note

If the host software version does not match the one applicable to the card, contact the vendor or the integrator for the right version.

For the introduction of card installation and host software upgrade, see the related part in H3C S9500 Series Routing Switches  Installation Manual.

As board types or specifications might change with product versions, you may need to obtain the latest documents from Technical Support & Document link on H3C website http://www.h3c.com

 

 

Hangzhou H3C Technologies Co., Ltd

 

download
>

Related Documentation