H3C S9500 LSB1SP4CA0 Card Manual(V1.01)
>

Table of Contents

H3C S9500 LSB1SP4CA0 Card Manual(V1.01)

Download

                                                                                         4端口OC-48c-POS光接口板 – LSB1SP4CA0

1  单板标识

前面板右上角标有丝印：SP4CA，用来标识该单板。

2  单板简介

                                                                                                                                                                                  表1 单板属性

属性

规格

接口连接器类型

SFP/LC

接口数量

4个2.5G POS光接口

接口传输速率

2.5Gbps

单板适用的机型

S9502/S9505/S9508/S9508V/S9512

单板适用的主机软件版本

1272及以上版本

 

可选用的SFP模块类型及其属性见下表。

                                                                                                                                                                   表2 SFP光接口模块描述

SFP模块名称

中心波长

SFP模块提供的用户接口连接器类型

接口光纤规格

光纤最大传输距离

2.5GBASE-FX-MM-SFP

1310nm

LC

50/125µm多模光纤

2km

62.5/125µm多模光纤

2.5GBASE-FX-SM-SFP

9/125µm单模光纤

15km

2.5GBASE-FX-SM-LR-SFP

40km

2.5GBASE-FX-SM-VR-SFP

1550nm

80km

 

3  注意事项

如主机软件版本不匹配，请联系该设备的销售商或集成商获取相应的主机软件版本；

单板安装说明及主机软件版本的升级方法请参见《H3C S9500系列路由交换机  安装手册》相关章节。

单板种类或规格可能随产品版本的变更而改变，请从公司网站http://www.h3c.com.cn主页上的“文档中心”获取最新资料。

 

 

杭州华三通信技术有限公司

 


                                                           4-Port OC-48c-POS Optical Interface Card – LSB1SP4CA0

1  Card Identifier

The silkscreen SP4CA is printed at the upper right corner of the front panel, and is used to identify the card.

2  Specifications

Table1  Card specifications

Item

Specification

Connector

SFP/LC

Port quantity

Four 2.5 Gbps POS optical ports

Transmission rate

2.5Gbps

Applied to

S9502/S9505/S9508/S9508V/S9512

Host software version

Version 1272 and above

 

For supported POS SFP modules, refer to the following table.

Table2  SFP Module Attribute

SFP module

Central wavelength

Connector

Matching cable

Transmission segment

2.5GBASE-FX-MM-SFP

1310 nm

LC

50/125 µm multimode optical fiber cable

2 km

62.5/125 µm multimode optical fiber cable

2.5GBASE-FX-SM-SFP

9/125 µm single mode optical fiber cable

15 km

2.5GBASE-FX-SM-LR-SFP

40 km

2.5GBASE-FX-SM-VR-SFP

1550 nm

80 km

 

3  Note

If the host software version does not match the one applicable to the card, contact the vendor or the integrator for the right version.

For the introduction of card installation and host software upgrade, see the related part in H3C S9500 Series Routing Switches Installation Manual.

As board types or specifications might change with product versions, you may need to obtain the latest documents from Technical Support & Document link on H3C website http://www.h3c.com.

 

 

Hangzhou H3C Technologies Co., Ltd

 


download
>

Related Documentation