H3C S9500 LSB1GP48DB0 Card Manual(V1.01)

48端口1000BASE-X SFP光接口板 – LSB1GP48DB0

1  单板标识

前面板右上角标有丝印：GP48DB，用来标识该单板。

2  单板简介

                                                                                                                                                                               表1 单板属性

可选用的SFP模块类型及其属性见下表。

                                                                                                                                                                表2 SFP光接口模块描述

3  注意事项

如主机软件版本不匹配，请联系该设备的销售商或集成商获取相应的主机软件版本；

单板安装说明及主机软件版本的升级方法请参见《H3C S9500系列路由交换机 安装手册》相关章节。

单板种类或规格可能随产品版本的变更而改变，请从公司网站http://www.h3c.com.cn主页上的“文档中心”获取最新资料。

杭州华三通信技术有限公司

48 x 1000BASE-X SFP Optical Interface Card – LSB1GP48DB0

1  Card Identifier

The silkscreen GP48DB is printed at the upper right corner of the front panel, and is used to identify the card.

2  Specifications

Table1  Card specifications

For supported POS SFP modules, refer to the following table.

Table2  SFP Module Attribute

3  Note

If the host software version does not match the one applicable to the card, contact the vendor or the integrator for the right version.

For the introduction of card installation and host software upgrade, see the related part in H3C S9500 Series Routing Switches Installation Manual.

As board types or specifications might change with product versions, you may need to obtain the latest documents from Technical Support & Document link on H3C website http://www.h3c.com

H3C Technologies Co., Ltd.