BOM: 3123A09W
1 单板标识
前面板左上角标有丝印LSQ1SRP2XB0，用来标识该单板。
2 单板简介
表1-1 LSQ1SRP2XB0属性
属性 | LSQ1SRP2XB0 |
接口连接器类型 | RJ-45、LC |
对外接口 | l 1个Console口，支持交换机的本地或远程拨号配置管理 l 1个管理用10/100BASE-TX接口 l 1个支持热插拔的CF卡接口 l 2个10GBase-R-XFP以太网业务接口 |
接口传输速率 | l Console口：≤115200bit/s，缺省为9600bit/s l 10Base-T/100Base-TX接口：10/100Mbit/s半/全双工；MDIX l 10GBase-X-XFP接口：10Gbit/s全双工 |
可选用线缆及最大传输距离 | l Console口：普通异步串行口电缆，传输距离≤15m l 10Base-T/100Base-TX接口：5类双绞线，传输距离100m l 10GBase-R-SFP接口属性请参见表1-2 |
单板适用的机型 | S7503E/S7506E /S7510E/S7506E-V以太网交换机 |
单板适用的主机软件版本 | Release 6000系列 |
可选用的XFP模块类型及其属性见下表。
表1-2 LSQ1SRP2XB0接口收发器及线缆描述
XFP模块名称 | 中心波长 | 接口连接器类型 | 接口光纤规格 | 光纤最大传输距离 |
XFP-SX-MM850 | 850nm | LC | 50/125µm多模光纤 | 300m |
XFP-LX-SM1310 | 1310nm | LC | 9/125µm单模光纤 | 10km |
XFP-LH40-SM1550 | 1550nm | LC | 9/125µm单模光纤 | 40km |
XFP-LH80-SM1550 | 1550nm | LC | 9/125µm单模光纤 | 80km |
如主机软件版本不匹配，可以联系该设备的销售商或集成商获取相应的主机软件版本。
单板安装说明及主机软件版本的升级方法请参见《H3C S7500E系列以太网交换机 安装手册》相关章节。
Copyright © 2007 杭州华三通信技术有限公司
Salience VI-10GE Service Processing Engine–LSQ1SRP2XB0
BOM: 3123A09W
1 Card Identifier
The silkscreen LSQ1SRP2XB0 is printed at the upper left corner of the front panel, and is used to identify the card.
2 Specifications
Table1 LSQ1SRP2XB0 specifications
Item | LSQ1SRP2XB0 |
Connector | RJ-45, and LC |
External interface | l One Console port : Support local/remote dialup configuration management of the switch l One 10/100BASE-TX interface for management l One hot-swappable interface for CF card l Two 10GBASE-X-XFP Ethernet ports |
Interface transmission speed | l Console port: £ 115,200 bps (default: 9,600 bps) l 10Base-T/100Base-TX interface: 10/100 Mbps (half/full duplex), MDIX. l 10GBASE-X-XFP interface: 10 Gbps (full duplex) |
Cable and maximum transmission distance | l Console port: Ordinary asynchronous serial port cable; maximum transmission distance: 15 m (49 ft). l 10Base-T/100Base-TX interface: Category-5 twisted pair; maximum transmission distance: 100 m (328 ft). l For information about 10GBase-X-SFP interface, see Table2 . |
Applied to | S7503E/S7506E /S7510E/S7506E-V Ethernet switch |
Host software version | Release 6000 series |
For supported XFP modules, refer to the following table.
Table2 Specifications for LSQ1SRP2XB0 interface transceiver and cable
Optional XFP module | Central wavelength | Connector type | Interface fiber specifications | Maximum transmission distance |
XFP-SX-MM850 | 850 nm | LC | 50/125 µm multi-mode optical fiber | 300 m (984 ft) |
XFP-LX-SM1310 | 1,310 nm | LC | 9/125 µm single-mode optical fiber | 10 km (6 mi) |
XFP-LH40-SM1550 | 1,550 nm | LC | 9/125 µm single-mode optical fiber | 40 km (25 mi) |
XFP-LH80-SM1550 | 1,550 nm | LC | 9/125 µm single-mode optical fiber | 80 km (50 mi) |
3 Note
If the host software version does not match the one applicable to the card, contact the vendor or the integrator for the right version.
For the introduction of card installation and host software upgrade, see the related part in H3C S7500E Series Ethernet Switches Installation Manual.
Copyright © 2007 Hangzhou H3C Technologies Co., Ltd.
