Comware V3 OM Release0201(V3.11)

1 Getting Started

introduces Comware V3 and user configuration interface.

2 System Management

introduces system maintenance management, file management, user interface configuration, NTP configuration, SNMP configuration and terminal services.

3. Interface

introduces how to configure interfaces supported by Comware V3, such as LAN interface, synchronous/asynchronous serial interface, CE1 interface, subinterface, virtual interface template and virtual Ethernet interface.

4. Link Layer Protocol

introduces the configuration of PPP, MP, PPPoE, SLIP, ISDN, VLAN, HDLC, Frame Relay, ATM, LAPB and X.25.

5. Network Protocol

introduces the configuration IP address, static address resolution, domain name resolution, IP performance, IP unicast policy routing, IP multicast policy routing and DLSw.

6.Routing Protocol

introduces the configuration of static routing, RIP, OSPF, IS-IS, BGP, MBGP, IP routing policy and IP route capacity.

7. Multicast Protocol

introduces the configuration of common multicast, IGMP, PIM DM, PIM SM, MSDP, MBGP and multicast static routing.

8. MPLS

introduces the architecture and basic capacity configuration of MPLS.

9. Security

introduces the configuration of AAA, RADIUS, firewall, NAT, IPSec and IKE.

10. VPN

introduces the configuration of L2TP, GRE, BGP/MPLS VPN and MPLS L2VPN.

11. QoS

introduces the configuration of traffic classification, traffic policing, traffic shaping, congestion management and congestion avoidance.

12. Reliability

introduces the configuration of standby center and VRRP.

13. Dial-up

introduces the configuration of DCC and Modem.

14. Voice

describes how to configure voice and fax services over network, such as VoIP, E1/T1, fax, voice RADIUS, GK client, and SIP client.

15. Non-IP Architecture

describes the configuration of OSI, IPX and DLSw.

16. Acronyms

lists all the acronyms used in the manuals.