- Released At: 31-10-2021
- Page Views:
- Downloads:
- Table of Contents
- Related Documents
-
LSXM1SFT08F2 switching fabric module
1 Identifier
The module identifier LSXM1SFT08F2 is on the right corner of the front panel.
2 Specifications
Table 1 Module specifications
Item |
Specification |
Processor |
dual-core @ 1.6 GHz |
SDRAM |
4 GB |
Power consumption |
165 W to 444 W |
CAUTION: Do not install switching fabric modules of different models on the same switch. |
IMPORTANT: · This module can be used only with Type T supervisor engine units (such as LSXM2SUPT2) and Type T interface modules (such as LSXM1TGS48TE2). · To verify the compatibility of the module with the software release you are using, see the release notes. · Remove the protection box from the module before you install the module. · You must install the modules before you install the fan trays, and remove the fan trays before you remove the modules. · Follow these instructions to use the ejector levers on the module: ¡ Before you install the module, release the ejector levers by pressing the spring clips. ¡ After the module is fully seated into slot, press the ejector levers inward until the spring clips lock it in place. ¡ Before you remove the module, release the ejector levers by pressing the spring clips. |
3 Related documentation
For information about module installation, see the installation guide for the device.
For software upgrade, see the release notes for the device.
Copyright © 2020-2021 New H3C Technologies Co., Ltd.
The information in this document is subject to change without notice.