- Released At: 18-11-2019
- Page Views:
- Downloads:
- Table of Contents
- Related Documents
-
48-port 10/100/1000BASE-T electrical Ethernet interface card—LSQM2GT48SA0
1 Card identifier
The card identifier LSQM2GT48SA0 is in the upper right corner of the front panel.
2 Specifications
|
IMPORTANT: Before installing the card, you must remove the protection cover from the card to ensure correct installation. |
Table 1 Card specifications
Item |
Specifications |
Card size (H × W × D) |
40 × 399 × 355 mm (1.57 × 15.71 × 13.98 in) |
SDRAM (DDR3) |
1GB |
Power consumption |
35 W to 45 W |
Connector type |
RJ-45 |
Ports |
48 |
Port rate |
10/100/1000 Mbps |
Transmission medium and max transmission distance |
100 m (328.08 ft) over Category 5 or higher twisted pair cables |
Applicable hardware platforms |
· All S7500E models · All S7500X models |
System software version |
Release 7178 and Later |
The 10/100/1000BASE-T copper port uses an RJ-45 connector.
Figure 1 RJ-45 connector
Table 2 RJ-45 GE connector pin assignment
Pin |
10BASE-T/100BASE-TX/1000BASE-T |
|
Signal |
Function |
|
1 |
MX_0+ |
Transmits and receives data |
2 |
MX_0- |
Transmits and receives data |
3 |
MX_1+ |
Transmits and receives data |
4 |
MX_2+ |
Transmits and receives data |
5 |
MX_2- |
Transmits and receives data |
6 |
MX_1- |
Transmits and receives data |
7 |
MX_3+ |
Transmits and receives data |
8 |
MX_3- |
Transmits and receives data |
3 Related documentation
For module installation, see H3C S7500E Switch Series Installation Guide and H3C S7500X Switch Series Installation Guide.
For software upgrade, see the release notes for the device.
Copyright © 2015-2018 New H3C Technologies Co., Ltd.
The information in this document is subject to change without notice.