- Released At: 06-06-2020
- Page Views:
- Downloads:
- Table of Contents
- Related Documents
-
LSXM1CGQ18QGHB1 18-port 100G QSFP28/36-port 40G QSFP+ Ethernet fiber interface card
1 Identifier
The card identifier LSXM1CGQ18QGHB1 is at the upper right corner of the front panel.
2 Specifications
Figure 1 Interface types and numbers
(1) QSFP28 ports |
(2) QSFP+ ports |
Table 1 Card specifications
Item |
Specification |
Processor |
MIPS64 (Dual Core) @ 1.2 GHz |
SDRAM |
16 GB DDR3 SDRAM |
Power consumption |
361 W to 565 W |
Interfaces |
18 × 100G QSFP28 ports + 18 × 40G QSFP+ ports Or 36 × 40G QSFP+ ports NOTE: A QSFP28 port acts as a QSFP+ port when operating at 40 Gbps. |
Transmission rate |
100/40 Gbps |
Compatible device models |
S12500X-AF Switch Series |
Compatible switching fabric modules |
Type H switching fabric modules |
|
CAUTION: This card can be used only with Type H switching fabric modules, which have a character string of SFH in their card identifiers (for example, LSXM1SFH16C1). Card damage will occur if this card is used with a switching fabric module that is not Type H. |
|
IMPORTANT: · To verify compatibility of the card with the software release you are using, see the release notes. · For information about transceiver modules and cables available for the card, see H3C S12500X-AF Switch Series Cards and Transceiver Modules Compatibility Matrixes. · If high-performance DDR memory is installed on the module (labelled with this installation information), see the release notes to verify the device software compatibility with the memory. |
|
NOTE: Switching fabric module slots are covered by fan trays. To verify the card identifiers of the switching fabric modules while the switch is operating, use the display device command. |
3 Related documentation
For card installation, see H3C S12500X-AF Switch Series Installation Guide.
For software upgrade, see the release notes for the device.
Copyright © 2020 New H3C Technologies Co., Ltd.
The information in this document is subject to change without notice.