Login
- Released At: 26-06-2020
- Page Views:
- Downloads:
- Table of Contents
- Related Documents
-
LSXM1SUPER1 supervisor engine unit
1 Identifier
The module identifier LSXM1SUPER1 is in the upper right corner of the front panel.
2 Specifications
Table 1 Module specifications
|
Item |
Specification |
|
Processor |
Intel processor (Quad Core) @ 2.2 GHz |
|
DDR |
32GB DDR4 (two DIMM slots) |
|
Flash |
4GB EMMC |
|
NVRAM |
512 KB |
|
SSD |
240 GB (SATA) |
|
Power consumption |
52 W to 70 W |
|
Connector |
· RJ-45 · LC · USB (Type A) · Mini-USB (Type AB) |
|
Interfaces |
· 1 × RJ-45 console port · 1 × mini-USB console port · 2 × 10/100/1000BASE-T ports for management and upgrade · 2 × GE SFP ports for management and upgrade · 1 × USB port (USB 3.0, Host port) · 2 × 1PPS/ToD time synchronization ports · 2 × SMB clock input ports · 2 × SMB clock output ports |
|
Transmission rate |
· Console port: ≤ 115200 bps (default: 9600 bps) · 10/100/1000BASE-T port: 10/100/1000 Mbps · SFP port: 1000 Mbps |
|
Transmission medium and max transmission distance of the console port |
15 m (49.21 ft) over an asynchronous serial cable |
|
Transmission medium and max transmission distance of the 10/100/1000BASE-T port |
100 m (328.08 ft) over a category-5 twisted pair cable |
|
Compatible device models |
S12516R switch router S12508R switch router |
|
|
IMPORTANT: · To verify compatibility of the module with the software release you are using, see the release notes. · You can access and configure the device through the RJ-45 console port or the mini-USB console port. Only one port is active at a time. · To connect a USB device to the module, make sure the USB device is in good condition. · Set the same speed and duplex mode for a management Ethernet port and its peer port. · If multiple management ports are connected to one remote switch, you must assign their peer ports to different VLANs on the remote switch. Login or file transfer will fail if the peer ports are in the same VLAN. · To transfer files from the BootWare menu through TFTP or FTP, you can use only the management port M0/0/3. · For information about transceiver modules and cables available for the module, see H3C S12500R Switch Router Series Cards and Transceiver Modules Compatibility Matrixes. |
3 Related documentation
For module installation, see the H3C S12500R Switch Router Series Installation Guide.
For software upgrade, see the release notes for the device.
Copyright © 2020 New H3C Technologies Co., Ltd.
The information in this document is subject to change without notice.
