- Released At: 08-05-2021
- Page Views:
- Downloads:
- Table of Contents
- Related Documents
-
LSXM1SFS08D2 fabric module
1 Identifier
The module identifier LSXM1SFS08D2 is in the upper right corner of the front panel.
2 Specifications
|
CAUTION: Do not install fabric modules of different models on the same device. |
Table 1 Module specifications
Item |
Specification |
Processor main frequency |
1 GHz |
BootROM |
16 MB |
SDRAM |
2 GB |
Dimensions (H × W × D) |
40 × 453 × 279 MM (1.57 × 17.83 × 10.98 in) |
Power consumption |
59 W to 145 W |
Compatible interface modules |
Type S interface modules |
Compatible supervisor engine units |
Type S supervisor engine units |
|
IMPORTANT: · This module can be used only with Type S supervisor engine units (such as LSXM1SUPS2) and Type S interface modules (such as LSXM1TGS48SE2). · To verify the compatibility of the module with the product models and software releases, see the release notes. · Remove the metal protection box from the module before you install the module. · A fan tray covers fabric module slots. You must install the modules before you install the fan trays, and remove the fan trays before you remove the modules. · Follow these instructions to use the ejector levers on the module: ¡ Before you install the module, release the ejector levers by pressing the spring clips. ¡ After the module is fully seated into the slot, press the ejector levers inward until the spring clips lock it in place. ¡ Before you remove the module, release the ejector levers by pressing the spring clips. |
3 Related documentation
For information about installing the module, see the installation guide for the device.
For information about upgrading system software, see the release notes.
Copyright © 2021 New H3C Technologies Co., Ltd.
The information in this document is subject to change without notice.