- Released At: 13-12-2023
- Page Views:
- Downloads:
- Table of Contents
- Related Documents
-
LSXM3SUP04S2 supervisor engine unit
1 Identifier
The module identifier LSXM3SUP04S2 is in the upper right corner of the front panel.
2 About the module
Table 1 Module specifications
Item |
Specification |
Flash |
2 GB |
BootROM |
32 MB |
NVRAM |
1 MB |
SDRAM |
16 GB |
Dimensions (H × W × D) |
40 × 201 × 412 mm (1.57 × 7.91 × 16.22 in) |
Power consumption |
27 W to 43 W |
Interfaces |
· 1 × console port · 1 × USB console port · 1 × USB port · 2 × network management ports: 1 × RJ-45 ports and 1 × SFP fiber ports |
Transmission rate |
· Console port: 9600 bps to 115200 bps ( default: 9600 bps ) · USB console port: ≤ 115200 bps (default: 9600 bps) · network management ports ( RJ-45 ): 10/100/1000 Mbps, half/full duplex · network management ports ( SFP ): 1000 Mbps |
Transmission medium and max transmission distance |
· Console port: 15 m ( 49.21 ft ) over asynchronous EIA/TIA-232 cables · USB console port: 10 m (32.81 ft) over a USB-AB cable · network management ports ( RJ-45 ): 100 m ( 328.08 ft ) over Category 5 or higher twisted pair cables · network management ports ( SFP ): GE SFP fiber module specification |
IMPORTANT: · This module can be used only with Type S fabric modules (such as LSXM3SFS04G2) and Type S interface modules (such as LSXM3TGS48SF2). · To verify the compatibility of the module with the product models and software releases, see the release notes. · For information about transceiver modules and cables available for the module, see the modules and transceiver modules compatibility matrixes for the device. · Before connecting the SFP network management port, make sure the peer Ethernet port operates at 1000 Mbps in full duplex mode. · The USB port does not support USB extension cables. |
The 10/100/1000BASE-T copper port uses an RJ-45 connector.
Figure 1 RJ-45 connector
Table 2 RJ-45 GE connector pinout
Pin |
10BASE-T/100BASE-TX/1000BASE-T |
|
Signal |
Function |
|
1 |
MX_0+ |
Transmits and receives data. |
2 |
MX_0- |
Transmits and receives data. |
3 |
MX_1+ |
Transmits and receives data. |
4 |
MX_2+ |
Transmits and receives data. |
5 |
MX_2- |
Transmits and receives data. |
6 |
MX_1- |
Transmits and receives data. |
7 |
MX_3+ |
Transmits and receives data. |
8 |
MX_3- |
Transmits and receives data. |
3 Related documentation
For information about module installation, see the installation guide for the device.
For software upgrade, see the release notes.
Copyright © 2021-2023 New H3C Technologies Co., Ltd.
The information in this document is subject to change without notice.