- Released At: 31-03-2021
- Page Views:
- Downloads:
- Table of Contents
- Related Documents
-
1 Identifier
The module identifier LSUM1FAB10XEC0 is in the upper right corner of the front panel.
2 Specifications
|
IMPORTANT: Before installing the module, you must remove the protection cover from the module to ensure correct installation. |
Table 1 Module specifications
Item |
Specifications |
BootROM |
8 MB |
SDRAM |
2 GB |
Dimensions (H × W × D) |
40 × 463 × 318 mm (1.57 ×18.23 × 12.52 in) |
Power consumption |
130 W to 214 W |
Connector type |
RJ-45 |
Ports |
1 × console port CAUTION: The port can only be used by H3C technical support for system maintenance and upgrade. If the device fails because you operate the port without authorization, H3C shall not be held liable for any consequence caused thereby. |
Applicable device models |
S10510X |
|
NOTE: · The OFFLINE button on the fabric module can only be used by technical support for system debugging and failure locating. · To verify the compatibility of the module with the software release you are using, see the release notes. |
3 Related documentation
For information about installing the module, see H3C S10500X Switch Series Installation Guide.
For information about upgrading system software, see the release notes for the device.
Copyright © 2021 New H3C Technologies Co., Ltd.
The information in this document is subject to change without notice.