- Released At: 31-03-2021
- Page Views:
- Downloads:
- Table of Contents
- Related Documents
-
LSUM1MPUS10XEC0 main processing unit with switching
1 Identifier
The module identifier LSUM1MPUS10XEC0 is in the upper right corner of the front panel.
2 Specifications
|
IMPORTANT: Before installing the module, you must remove the protection cover from the module to ensure correct installation. |
Table 1 Module specifications
Item |
Specifications |
Flash |
4 GB |
BootROM |
8 MB |
NVRAM |
1 MB |
SDRAM |
8 GB |
Dimensions (H × W × D) |
40 × 463 × 318 mm (1.57 × 18.23 × 12.52 in) |
Power consumption |
152 W to 240 W |
Ports |
· 1 × console port · 1 × USB console port · 4 × network management ports: 2 RJ-45 ports and 2 SFP fiber ports · 1 × primary USB port |
Port rate |
· Console port: 9600 bps to 115200 bps (default: 9600 bps) · USB console port: ≤ 115200 bps (default: 9600 bps) · RJ-45 network management port: 10/100/1000 Mbps, half/full duplex · SFP network management port: 1000 Mbps |
Transmission medium and max transmission distance |
· Console port: 15 m (49.21 ft) over an asynchronous EIA/TIA-232 cable · USB console port: 10 m (32.81 ft) over a USB-AB cable · RJ-45 network management port: 100 m (328.08 ft) over a Category 5 or higher twisted pair cable · SFP network management port: GE SFP transceiver module |
Applicable device models |
S10510X |
|
NOTE: · The OFFLINE button on the MPU can only be used by technical support for system debugging and failure locating. · The USB port does not support USB extension cables. · To verify the compatibility of the module with the software release you are using, see the release notes. |
The 10/100/1000BASE-T port uses an RJ-45 connector.
Figure 1 RJ-45 connector
Table 2 RJ-45 GE connector pinout
Pin |
10BASE-T/100BASE-TX/1000BASE-T |
|
Signal |
Function |
|
1 |
MX_0+ |
Transmits and receives data. |
2 |
MX_0- |
Transmits and receives data. |
3 |
MX_1+ |
Transmits and receives data. |
4 |
MX_2+ |
Transmits and receives data. |
5 |
MX_2- |
Transmits and receives data. |
6 |
MX_1- |
Transmits and receives data. |
7 |
MX_3+ |
Transmits and receives data. |
8 |
MX_3- |
Transmits and receives data. |
|
IMPORTANT: For more information about transceiver modules and cables available for the module, see H3C S10500X Switch Series Cards and Transceiver Modules Compatibility Matrixes. |
3 Related documentation
For information about installing the module, see H3C S10500X Switch Series Installation Guide.
For information about upgrading system software, see the release notes.
Copyright © 2021 New H3C Technologies Co., Ltd.
The information in this document is subject to change without notice.